Hi!
I'm a retired commercial pilot and since my retirement after 12,500 hrs of flight, I began modeling FS airplanes.
A lot of time was invested in models and FDE's to get apearance & performance very close to real. The intention is when you fly these models it would be like the real plane.
Comments and suggestions are welcome. Any doubt, e-mail to narcizo@linhalivre.net and I will sure reply.

Thanks to:
- Denis da Silva who was my consultant when I began with FSDS.
- A. C. Lucena for FDE analisys and test flights.

How to fly this model:

TAKE-OFF:
- maintain a little press to front in stick to acquire a horizontal attitude;
- at 60 mph pull the stick to leave the ground;
- set the throttle to 2,200 rpm. Maintain 65/70 mph while climbing to the cruise level. The initial rate is around +700 fpm.

CRUISE:
- 100 mph IAS at 5,000 ft, rpm=2,100 (longest range)
- 105 mph IAS at 5,000 ft, rpm=2,200

LANDING:
- Decrease speed to 65 mph and set flaps to 10 degrees;
- set throttle to 1,500 rpm;
- at short final approach, flaps to 20 or full.

Please send your comments to narcizo@linhalivre.net and get to know my others models.
Thanks for downloading my model.

J.E.Narcizo

----------------------------------------
LEGAL WARNING
Copyright: RanchoJEN models - Brazil
This software is FREEWARE - you don't have to pay nothing for it.
Any commercial use (including upload to a pay-to-enter site and any other use in wich a money exchange is involved) IS PROHIBITED without the author permission.
Also any repacking, reworking or any kind of manipulation of these files is not allowed.

All models by RanchoJEN have a little LOGO on right side of fuse, under the h.stab.
----------------------------------------

REPAINTS:
You are welcome to repaint to this model as long as they remain freeware.